nkoriginal
14/04/2008, 17:48
Nose si has podido solucionar el problema.
Pero yo tengo el mismo problema, y encontre esta respuesta en la pagina de plesk
http://kb.swsoft.com/en/3563
Espero que te sea de ayuda.
Te dejo el texto por si no puedes entrar a la pagina
SYMPTOMS
After upgrade to 8.3.0, when I run an on-demand scan in the Watchdog module by hitting the green start button and I get this message:
Scanning is in progress. About 30 minutes left.
and a progress bar that remains empty for a few minutes until the next message:
Scanning Status reads: "The scanner has never been started."
RESOLUTION
This issue occurs due to bug in PHP 5.2.3 that is used by Plesk CP since 8.3 version.
As workaround you can disable 'auto_globals_jit' in Plesk PHP configuration:
# sed -i 's/auto_globals_jit = On/auto_globals_jit = Off/' /usr/local/psa/admin/conf/php.ini
# /etc/init.d/psa restart1
Pero yo tengo el mismo problema, y encontre esta respuesta en la pagina de plesk
http://kb.swsoft.com/en/3563
Espero que te sea de ayuda.
Te dejo el texto por si no puedes entrar a la pagina
SYMPTOMS
After upgrade to 8.3.0, when I run an on-demand scan in the Watchdog module by hitting the green start button and I get this message:
Scanning is in progress. About 30 minutes left.
and a progress bar that remains empty for a few minutes until the next message:
Scanning Status reads: "The scanner has never been started."
RESOLUTION
This issue occurs due to bug in PHP 5.2.3 that is used by Plesk CP since 8.3 version.
As workaround you can disable 'auto_globals_jit' in Plesk PHP configuration:
# sed -i 's/auto_globals_jit = On/auto_globals_jit = Off/' /usr/local/psa/admin/conf/php.ini
# /etc/init.d/psa restart1