OVH Community, your new community space.

Duda disco


Rogero
08/07/2014, 00:25
muchas gracias por tu ayuda, acabo de generar el ticket.


Saludos.

Ros
07/07/2014, 18:47
Parece que si lo tienes algo jodido, a mi me han cambiado muchos discos en este estado, así que, envíales ticket y si tienes RAID que te lo cambien, no tienes nada que perder !

Saludos.

Rogero
07/07/2014, 17:22
Hola amigos, quiero saber según sus experiencias si este disco esta con problemas:


smartctl 5.41 2011-06-09 r3365 [x86_64-linux-3.10.23-xxxx-std-ipv6-64-rescue] (local build)
Copyright (C) 2002-11 by Bruce Allen, http://smartmontools.sourceforge.net

=== START OF INFORMATION SECTION ===
Device Model: HGST HDS724040ALE640
Serial Number: PK1301PAH6NV2X
LU WWN Device Id: 5 000cca 22bd11ff7
Firmware Version: MJAOA580
User Capacity: 4,000,787,030,016 bytes [4.00 TB]
Sector Sizes: 512 bytes logical, 4096 bytes physical
Device is: Not in smartctl database [for details use: -P showall]
ATA Version is: 8
ATA Standard is: ATA-8-ACS revision 4
Local Time is: Mon Jul 7 17:14:51 2014 CEST
SMART support is: Available - device has SMART capability.
SMART support is: Enabled

=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED

General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 24) seconds.
Offline data collection
capabilities: (0x5b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 255) minutes.
SCT capabilities: (0x003d) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.

SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000b 100 100 016 Pre-fail Always - 0
2 Throughput_Performance 0x0005 136 136 054 Pre-fail Offline - 80
3 Spin_Up_Time 0x0007 135 135 024 Pre-fail Always - 557 (Average 591)
4 Start_Stop_Count 0x0012 100 100 000 Old_age Always - 15
5 Reallocated_Sector_Ct 0x0033 100 100 005 Pre-fail Always - 2
7 Seek_Error_Rate 0x000b 100 100 067 Pre-fail Always - 0
8 Seek_Time_Performance 0x0005 117 117 020 Pre-fail Offline - 36
9 Power_On_Hours 0x0012 099 099 000 Old_age Always - 7450
10 Spin_Retry_Count 0x0013 100 100 060 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 15
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 515
193 Load_Cycle_Count 0x0012 100 100 000 Old_age Always - 515
194 Temperature_Celsius 0x0002 139 139 000 Old_age Always - 43 (Min/Max 23/49)
196 Reallocated_Event_Count 0x0032 100 100 000 Old_age Always - 2
197 Current_Pending_Sector 0x0022 100 100 000 Old_age Always - 24
198 Offline_Uncorrectable 0x0008 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x000a 200 200 000 Old_age Always - 0

SMART Error Log Version: 1
ATA Error Count: 6717 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.

Error 6717 occurred at disk power-on lifetime: 7375 hours (307 days + 7 hours)
When the command that caused the error occurred, the device was active or idle.

After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 08 f0 f6 7e 06 Error: UNC at LBA = 0x067ef6f0 = 108984048

Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 80 28 f0 f6 7e 40 00 17:25:20.073 READ FPDMA QUEUED
60 08 20 f0 f6 7e 40 00 17:25:20.073 READ FPDMA QUEUED
2f 00 01 10 00 00 40 00 17:25:20.073 READ LOG EXT
60 08 10 f0 f6 7e 40 00 17:25:17.242 READ FPDMA QUEUED
60 80 08 f0 f6 7e 40 00 17:25:17.242 READ FPDMA QUEUED

Error 6716 occurred at disk power-on lifetime: 7375 hours (307 days + 7 hours)
When the command that caused the error occurred, the device was active or idle.

After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 80 f0 f6 7e 06 Error: UNC at LBA = 0x067ef6f0 = 108984048

Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 08 10 f0 f6 7e 40 00 17:25:17.242 READ FPDMA QUEUED
60 80 08 f0 f6 7e 40 00 17:25:17.242 READ FPDMA QUEUED
2f 00 01 10 00 00 40 00 17:25:17.242 READ LOG EXT
60 80 f8 f0 f6 7e 40 00 17:25:14.412 READ FPDMA QUEUED
60 08 f0 f0 f6 7e 40 00 17:25:14.412 READ FPDMA QUEUED

Error 6715 occurred at disk power-on lifetime: 7375 hours (307 days + 7 hours)
When the command that caused the error occurred, the device was active or idle.

After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 08 f0 f6 7e 06 Error: UNC at LBA = 0x067ef6f0 = 108984048

Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 80 f8 f0 f6 7e 40 00 17:25:14.412 READ FPDMA QUEUED
60 08 f0 f0 f6 7e 40 00 17:25:14.412 READ FPDMA QUEUED
2f 00 01 10 00 00 40 00 17:25:14.412 READ LOG EXT
60 08 e0 f0 f6 7e 40 00 17:25:11.599 READ FPDMA QUEUED
60 80 d8 f0 f6 7e 40 00 17:25:11.599 READ FPDMA QUEUED

Error 6714 occurred at disk power-on lifetime: 7375 hours (307 days + 7 hours)
When the command that caused the error occurred, the device was active or idle.

After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 80 f0 f6 7e 06 Error: UNC at LBA = 0x067ef6f0 = 108984048

Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 08 e0 f0 f6 7e 40 00 17:25:11.599 READ FPDMA QUEUED
60 80 d8 f0 f6 7e 40 00 17:25:11.599 READ FPDMA QUEUED
2f 00 01 10 00 00 40 00 17:25:11.598 READ LOG EXT
60 80 c8 f0 f6 7e 40 00 17:25:08.677 READ FPDMA QUEUED
60 08 c0 f0 f6 7e 40 00 17:25:08.677 READ FPDMA QUEUED

Error 6713 occurred at disk power-on lifetime: 7375 hours (307 days + 7 hours)
When the command that caused the error occurred, the device was active or idle.

After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 08 f0 f6 7e 06 Error: UNC at LBA = 0x067ef6f0 = 108984048

Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 80 c8 f0 f6 7e 40 00 17:25:08.677 READ FPDMA QUEUED
60 08 c0 f0 f6 7e 40 00 17:25:08.677 READ FPDMA QUEUED
2f 00 01 10 00 00 40 00 17:25:08.677 READ LOG EXT
60 08 b0 f0 f6 7e 40 00 17:25:05.747 READ FPDMA QUEUED
60 80 a8 f0 f6 7e 40 00 17:25:05.747 READ FPDMA QUEUED

SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed without error 00% 65 -
# 2 Short offline Completed without error 00% 64 -
# 3 Short offline Completed without error 00% 64 -
# 4 Short offline Completed without error 00% 9 -
# 5 Short offline Completed without error 00% 9 -
# 6 Short offline Completed without error 00% 1 -

SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.


Cuanto trato de mover algunos archivos desde ese disco a otro me da error, y en algunos casos la información de corrompe.
Quiero preguntarles a ustedes antes de abrir algun ticket.


saludos.